The tracker seat is hand made with fiberglass cloth, read to be lightly sanded and painted. This is a slightly smaller and more streamlined version of typical street tracker seats. Overall length is approx. 24". See photos for dimensions.
Optional 3/4" thick, high-density neoprene seat foam can be cut with a utility knife and shaped with sandpaper to match the contour of your seat. Can be applied with 3M spray adhesive. Weather resistant. 12" x 20" sheet. An example of how to cut, shape, and apply the foam can be found in the Ryca CS Tracker Assembly Guide
Note: The seats are made-to-order, so please allow 1-2 weeks for shipment.
The seat is shown below mounted on the Ryca CS Tracker with optional seat foam and tail light.
WARNING: Rear area of tail section is NOT for passengers or gear.
The neoprene rubber seat foam can be cut with an x-acto knife and then shaped with 80 grit sandpaper.